| Economic Study on Switchgear Configuration in Electrical Systems of Offshore Wind Farms With Cable Outage |
Along with the rapid development of offshore
wind farms, the internal electric system of them has caused wide
public concern. In this paper the economy of switchgear
configuration for offshore wind farms is researched and based
on traditional switchgear configuration the switchgear complete
configuration and the switchgear partial configuration are put
forward respectively; after the comprehensive consideration of
two factors, i.e., the cost of investment and the fault opportunity
cost due to the fault of submarine cable, the total costs of
above-mentioned three switchgear configuration are assessed,
and the sensitivity analysis on such factors impacting total cost
as the price of switchgear, cable failure rate and maintenance
time of failure is performed. Analysis results show that considering the economy, the switchgear partial configuration is
the best one in the three switchgear configurations |
other |
Wang |
pdf |
[Download] |
| Simulation of Switching Over2voltages in the Collector Networks of Off shore Wind Farm |
As off shore wind farms are getting larger and larger , the research on their collector networks has att racted growing
international concerns recently. The switching over2voltages of the collector networks with and without running cable feeders
are analyzed using PSCAD/ EMTDC software , and the principles of two kinds of switching over2voltages are explained. Then
the impact of different design parameters on the switching over2voltage are investigated to provide references for the design of
the collector networks and of step2up t ransformer insulation.
This work is supported by National Natural Science Foundation of China (No. 50977050 , No. 50823001) . |
scholarly paper |
Wang |
pdf |
[Download] |
| Integration of wind power and Impact on power transfer and power flow in Chifeng power grid |
Being a clean, renewable energy with the capability of large scale application, wind
energy has attracted more and more attention. Wind power has also been developed rapidly. At the
mean time, the integration of large capacity of wind power to the power grid has brought a big
challenge to the power grid. Chifeng Power Grid, which transfers its main power to the other
power grid, has got many problems of the injected wind power. In this study, the model of the
power grid with wind farms has been built in the well-known simulation software PowerFactory.
The power transfer and power flow has been analyzed at different cases such as maximum wind
power, minimum wind power, maximum load, minimum load, respectively. The boundary of the
transferring power to accept the wind power has been certified by the “N-1” criteria. At last, it is
proposed to improve the capability of the power transfer according to the simulation results. |
scholarly paper |
Wang |
pdf |
[Download] |
| Flexible Technique for Camera Calibration |
We propose a flexible new technique to easily calibrate a camera. It is well suited for use without specialized knowledge of 3D geometry or computer vision. The technique only requires the camera to observe a planar pattern shown at a few (at least two) different orientations. Either the camera or the planar pattern can be freely moved. The motion need not be known. Radial lens distortion is modeled. The proposed procedure consists of a closed-form solution, followed by a nonlinear refinement based on the maximum likelihood criterion. Both computer simulation and real data have been used to test the proposed technique, and very good results have been obtained. Compared with classical techniques which use expensive equipment such as two or three orthog- onal planes, the proposed technique is easy to use and flexible. It advances 3D computer vision one step from laboratory environments to real world use. |
scholarly paper |
Zhan |
pdf |
[Download] |
|
My CV |
other |
Wing Kin |
pdf |
[Download] |
| Transducers'09 |
Development of a shock acceleration microswitch with enhanced-contact and low off-axis sensitivity. |
presentation |
Zhuoqing YANG |
pdf |
[Download] |
| IEEE NEMS2008 |
Design and contact dynamics simulation of an inertia micro-switch based on non-silicon substrate. |
presentation |
Zhuoqing YANG |
pdf |
[Download] |
| J. Micromech. Microeng. |
Analysis and elimination of the skip contact phenomenon in an inertial micro-switch for prolonging its contact time. |
scholarly paper |
Zhuoqing YANG |
pdf |
[Download] |
| J. Micromech. Microeng. |
Design, simulation and characterization of an inertia micro-switch fabricated by non-silicon surface micromachining. |
scholarly paper |
Zhuoqing YANG |
pdf |
[Download] |
| IEEE Trans. Electron Devices |
A MEMS inertia switch with bridge-type elastic fixed electrode for long duration contact. |
other |
Zhuoqing YANG |
pdf |
[Download] |
| Journal of Micromechanics and Microengineering |
Design, simulation and characterization of an inertia micro-switch fabricated by non-silicon surface micromachining.J. Micromech. Microeng. 2007,17 1598-1604 doi: 10.1088/0960-1317/17/8/024 |
scholarly paper |
Zhuoqing YANG |
pdf |
[Download] |